Lionel Trains 71-8340-250 - Manual (Page 24)

TrainMaster Command Control operations
Reprogramming your locomotives to restore features
I f your locomotives are unresponsive to your commands in the TrainMaster Command Control
environment, we recommend that you follow this procedure to reset your locomotive set.
Perform this procedure on only one unit at a time. Do not attempt to reprogram both
units simultaneously.
1. Slide the Command reverse unit switch to the PGM position. See Figure 1 on page 7 for the
locations of the Command reverse unit switches on each unit.
2. Plug in and connect your Command Base.
3. Place your locomotive on the track, then power up the track.
4. Press ENG and enter the locomotive’s ID#.
5. Press SET.
6. Press ENG and enter the locomotive’s ID# again.
7. Press AUX1.
8. Enter 8 for this particular locomotive.
8. Turn off track power and wait ten seconds.
10. Slide the Command reverse unit switch back to the RUN position.
At this point, your locomotive has been reset. Restore power to the track and operate the
locomotive as usual. Be sure to use the ID# entered in Step 4.
24
Note!