LG LST-3410A - Manual (Page 9)

9
INTRODUCTION
Connection Panel
Do not touch the inner pins of the
jacks on the rear panel.
Electrostatic discharge may cause
permanent damage to the unit.
AC Power Cord
Plug into the power source.
ANT IN
Connect to over-the-air outdoor/indoor antenna.
G-LINK
Gemstar cable box control connector. Connect G-LINK cable (supplied with your set-top box) to
make timed recordings using the TV Guide On Screen™ feature.
Note: If there is a “demo pin” in the jack, remove it to disable demo mode.
AUDIO/VIDEO INPUT 1, 2
Connect audio/video output of an external source (Audio system, TV/Monitor,
VCR, Camcorder).
VIDEO OUT 1, 2
Connect to TV with composite video inputs.
COMPONENT OUTPUT
Connect to TV with YPbPr input.
AUTHORIZED SERVICE ONLY
Is used only for authorized service purposes.
DVI OUT
Connect to TV with DVI connection.
CABLE IN
Connect to cable TV (CATV) signal source.
S-VIDEO OUT
Connect to TV with S-Video input.
Fixed “volume” AUDIO OUT (Left/Right)
Connect to a TV, amplifier, receiver or stereo system.
You cannot adjust the volume of this audio out on HD DVR.
Variable “volume” AUDIO OUT (Left/Right)
Connect to a TV, amplifier, receiver or stereo system.
You can adjust the volume of this audio out on HD DVR.
RGB OUT
Connect to TV with RGB input.
IEEE-1394
Connect to IEEE-1394 equipment.
DIGITAL AUDIO OUT (OPTICAL)
Connect to digital (optical) audio equipment.