Lincoln Electric LN-10 HEADS & CONTROLS IM587-B - Manual (Page 22)

B-5 OPERATION B-5
Minimum Limits Setting Mode Selection
The LN-10 control is set up for allowing a minimum weld
WFS and arc voltage setting for each procedure by set-
ting S2 DIP Switch 6 (Labeled “-”).
S2 switch 6 ON - Minimum Limits Setting mode ON
When Minimum Limits Setting mode is selected, all keys
except the procedure key are disabled. Welding is not
allowed while in this mode. The mode is used for mini-
mum limits setup only. See “Limits Setting Mode” in this
section for the correct procedure for setting the WFS and
voltage limits.
S2 switch 6 OFF = Minimum Limits Setting mode OFF
(As shipped)
LN-10
M 4 S R + -
S2 ON
S2
1 2 3 4 5 6 7 8
M 4 S R + -
S2 ON
S2
1 2 3 4 5 6 7 8