Light & Motion VX2000 - Manual (Page 11)

21 20
Assembly with Universal Mounts
Mounting Arm to Light Heads
Align top of arm with arm light head base and press FIRMLY together. Arm
should snap into position. (ref. fig. 25).
Removing Arm from Light Heads
To remove light head from arm, “break” the arm at the upper most joint.
Applying pressure on the Light Arm and not the Light Head (ref. fig. 9). Do
not apply pressure to the Light Head Base (ref. fig. 26). Doing so may cause
the Base to break from the Light Head damaging the light.
Connecting Battery to Light Head
1) Plug in the cable connectors on pod.
2) Tighten the locking sleeves by rotating clockwise until tight.
1) Plug in the cable connectors on the Light Head
2) Tighten the locking sleeves by rotating clockwise until tight.
(Fig. 25) (Fig. 26)
Light Head
Base
Mounting Light Head QuickConnect
1) Remove the attached arm mount using a 1/8 allen wrench.
2) Align QuickConnect details with slots on light head.
3) Tighten Socket Cap Screw to secure mount to light head.
Mounting QuickConnect Base
1) Remove arm base using 5/32 allen wrench.
2) Attach QuickConnect and tighten Socket Cap Screw.
Attaching Light Arm to Light and Housing
1) Align arm mounts into slots on light or housing base.
2) Push slightly and rotate clockwise. Arm should click into place.
Removing Light Arm from Light Head and Housing (ref. fig. 22)
1) Pull lock ring away from light or housing and rotate counter-clockwise.
(Fig. 22)
(Fig.24) (Fig. 23)
(Fig.27)