Light & Motion VX2000 - Manual (Page 9)

Bluefin VX2000 Lights - Getting Started
Pictured below are the components of both the SunRay -X Pro and the
SunRay -X Elite lighting systems. Take a moment to familiarize yourself with
each part for later identification and use.
Battery Pods
Pro light heads
Charger and
electrical cord
Light Arms
Light Cable
NiMH Batteries
16
6) Press the Handle Cap into the handle assembly so O-ring seals evenly.
7) Replace both hex screws in Handle Cap and tighten using hex key.
Smart Grip O-ring and Battery Kit (part # 802-0117) (ref. fig. 16)
Kit contains one O-ring and battery set for one Smart Grip.
Reversing Smart Grip left and right functionality
Smart Grips can be programmed to swap left and right button functions. This
is useful if a Smart Grip battery becomes exhausted during a dive. You then
can swap Smart Grip functions to maintain primary housing operation.
This is a total button function swap, not a button by button
nor a custom configuration.
1) Press either FAR/- and NEAR/+ or TELE and WIDE simultaneously and
hold for three seconds.
Button functions are now swapped. New button configuration will mirror
old configuration, i.e. REC and PHOTO, AF/OFF and PHOTO DIS.
This is a handle-by-handle procedure. Performing this function on one
handle will not switch both.
Revert to original button configuration
1) Perform the same swap procedure. Press either FAR/- and NEAR/+ or
TELE and WIDE simultaneously and hold for three seconds.
Eventually the batteries in the Smart Grips will totally exhaust. Contact
Light & Motion to order a replacement battery and O-ring kit (part #802-
0117). Or remove the Smart Grip handle cover and Replace the two batteries
located inside. Batteries are CR 1/3 N and can usually be purchased from
any store that stocks camera and watch batteries.
(Fig. 15) (Fig. 16)
Battery Pods
Elite light heads
Charger and
electrical cord
Light Arms
NiMH Batteries
Pod Locker
Pod Locker