Lucent Technologies MDW 9000/9010 - Manual (Page 5)

3
␣Line Buttons ␣
The lower buttons are programmed as shown below. 3,4, and 5 are programmable line buttons
that you can program with features (p. 22). One may be programmed as a Feature button
(p. 10) if you enter account codes (p. 11) during calls.
ON MSG
RANGE BATT
PSTAT 18
DROP ICOM/SA (R) ICOM/SA (V)
5 4 3
The Voice Announce setting should be turned off because the handset does not have a speaker
function. The system manager can turn Voice Announce off at your extension through system
programming.
To turn Voice Announce off with your handset:
1. Turn the phone on and press the imprinted Feat button; then dial 00.
2. Press any ICOM or SA button.
3. Dial ✻✻10.
4. Press the imprinted Feat button; then dial 00 to exit program mode.
You cannot be assigned to a paging group.
Ringing options should be used with caution.
␣Using a Feature Button␣
To use many system features, you can either program a Feature button or dial # before entering a
feature code. You only need a programmed Feature button in order to enter account codes (p. 11)
during calls. For details about programming a Feature button, see p. 10. If a Feature button is
programmed, there will be two Feature buttons on the handset:
• The programmed Feature button. If you choose to program a Feature button, use the top right
line button for this purpose (button 5, above).
• The factory-set imprinted Feat button (see p. 1) on the handset, located beneath the dialpad.
This imprinted Feat button is used to program buttons and settings (see p. 22).
Throughout this book, we refer to the programmed Feature button. The telephone Feat button used
to enter program mode is the imprinted Feat button.