Land Pride 330-114A RC/RCM5020 - Manual (Page 3)

3 3/11/10 Manual No. 330-148M
Assembly Instructions
Baffle Installation (Left Wing Shown)
Figure 2
Refer to Figure 1 on page 2:
1.
Locate and drill twelve 9/16" dia. holes on each wing
deck as shown in Figure 1. If holes already exist, skip
to step 2 below.
Refer to Figure 2:
2.
The wings should be raised and locked into position
for the remainder of the assembly.
3. Attach four front baffles (#1) to the left-hand wing
deck with 1/2"-13 x 1 1/2" GR5 hex head bolts (#2),
1/2" flat washers (#4) and 1/2" hex whiz nut (#3).
4. Tighten nuts to 76 ft-lbs of torque.
5. Repeat steps 3 & 4 for the right-hand wing deck.
NOTE: Drilling holes is not necessary on models
manufactured after Serial No. 536742. Skip to
step 2 below if cutter Serial No. is 536743 or higher.
2. Place tractor gear selector in park and/or set brakes,
shut engine off and remove ignition key.
3. Disconnect main driveline from tractor PTO.
Shredder/Fixed Blade/Baffle Kit
Kit No. 330-309A
This Kit consist of Kits 330-114A and 330-308A.
Therefore, see Kit No. 330-114A below for assembly
instructions of the front baffles and Kit No. 330-308A on
page 4 for assembly instructions of the shredder blades
and fixed blades.
Front Baffle Kit
Kit No. 330-114A
A detailed listing of parts for this accessory kit is provided
on page 10. Use the list as a checklist to inventory parts
received. Please contact your local Land Pride dealer for
any missing hardware.