Land Pride 330-114A RC/RCM5020 - Manual (Page 4)

4 Manual No. 330-148M 3/11/10
Assembly Instructions
Shredder/Fixed Blade Kit
Kit No. 330-308A
A detailed listing of parts for this accessory kit is provided
on page 11. Use the list as a checklist to inventory parts
received. Please contact your local Land Pride dealer for
any missing hardware.
Refer to Figure 3 & Figure 4:
1.
Remove all three existing blade carrier assemblies
(not shown) from the gearbox output shafts (A & B).
Keep flat washers (C), slotted hex nuts (D) and cotter
pins (E) for reuse.
Right Wing Shredder Assembly
(Part No. 330-228S)
Refer to Figure 3:
1.
Attach right wing shredder assembly (#1) to gearbox
output shaft (A) with existing washer (C) and slotted
hex nut (D). Torque slotted nut to 550 ft./lbs.
2. Install cotter pin (E) in the slotted nut and through
output shaft (A). Secure cotter pin (E) by bending its
legs around the nut.
Center Deck & Left Wing Shredder Assembly
(Part No’s. 330-302S)
Refer to Figure 4:
1.
Attach center deck and left wing shredder
assemblies (#2) to gearbox output shafts (B) with
existing washer (C) and slotted hex nut (D). Torque
slotted nut to 550 ft./lbs.
2. Install cotter pin (E) in the slotted nut and through
output shaft (B). Secure cotter pin (E) by bending its
legs around the nut.
IMPORTANT: Read “Safety Information” on page 1
before installing shredder blades.
Right Wing Shredder Assembly (P/N 330-228S)
Figure 3
Center Deck Shredder Assembly (P/N 330-302S)
And Left Wing Shredder Assembly (P/N 330-302S)
Figure 4
Clockwise Rotation
25601
Counterclockwise Rotation
25601