Lumens Technology PS750 - Manual (Page 15)

English - 14
Chapter 5 Start Using
<Note>: Please adjust it to be suitable for the local voltage frequency of
50/60Hz. For the frequency in actual use, please refer to the
manual. (
Attachment 1 )
1. Remove the lens cap.
2. Pull up the camera and the camera arm. The camera should aim at the
center of the presenter.
3. Pull up the lamp arm to a proper position.
4. Place an object to be displayed under the camera.
5. Press [POWER] on the remote control or control panel to power on.
6. Press [AUTO TUNE] on the control panel to optimize the image.
You are ready to present.
7. Each time the camera head is moved, press [AF] on the remote
control or control panel to refocus the lens.
<Note>: According to your request, you can adjust the camera head
slightly to aim at the center of the documents when the anchor
of lens was reached.
 When using the remote control, aim at the receptor on the PS750, and
press the power button.
 Once PS750 is turned on, the LED on the control panel will flash a few
times and stay lit. Please contact your distributor if the LED is not on.