Loewe CONNECT 37 - Manual (Page 20)

- 20
Daily operation
Adjusting the sound
Switching sound on/off
Sound off;
Sound on: Press button again or set volume V+.
Setting the volume
V+/V– volume louder / quieter.
The volume bar will be shown briefly if no other menu is
displayed.
Call sound adjustment
Call Sound adjustment.
Select sound adjustment by pressing several times.
or:
 Select sound adjustment.
Other sound settings in volume setting and sound adjustment
ž
adjustment is still visible:
 Call additional sound settings.
 Select sound setting,
 Go to the menu line below.
 Make changes.
Sound settings via the TV menu
ž
Call TV menu.
 Select Sound,
 go to the menu line below.
 Select desired sound setting,
 Go to the menu line below.
 Make changes.
Explanations of the sound settings:
Playback over the TV speakers, active speakers, Loewe Auro,
Loewe Sound Projector or an external hi-fi amplifier.
The selection active speakers, hi-fi/AV amplifier or Sound
Projector is only possible if these have been logged in in
the audio component wizard. The Auro selection is only
possible if a Loewe DVD Preceiver Auro is connected.
The menu item Sound via does not appear if TV speak-
ers or TV speakers + active subwoofer is set in the audio
components wizard.
Set sound effects Stereo, Panorama, 3D Surround.
Panorama gives the stereo sound a virtual base widen-
ing. 3D Surround converts a stereo signal into a virtual
surround signal.
Speech, Classical, Pop, Custom music and film sound. You
can set the treble and bass for music and movie sound.
Adjust the headphones volume.
Proper boost of bass and treble tones at low volume.
call with OK.
Selection possibility Mono/Stereo or Sound 1 or Sound
2 for two-sound broadcasts separately for speakers and
headphones. Only available with analogue stations.
Reduces volume differences, e.g. for advertisements that
are too loud.
Sound selection for two sound broadcasts.
Determining the maximum volume that can be set.
Specify the volume that is set when switching on the TV
set with the power switch. This does not affect switching
the set on from standby mode.
The volume can differ according to the individual stations.
If the sound is too loud or too quiet in relation to other
stations, adapt the volume. When the menu is open, you
can select the stations one after another with P+/P– and
adjust every single station conveniently.
Set Stereo balance so that the volume impression is identical
on the left and right.
Sound via
Sound effects
Sound
adjustment
Headphones vol.
Loudness
more ...
Loudspeaker/
Headphone
sound
Auto Volume
AV output
signal
Maximum
volume
Switch on
volume
Volume
adjustment for
current station
Balance
END
Sound adjustment Sound effects Volume
24
Headphone vo
Classical
Sound adjustment ...
Speech off Pop Custom music sound