Loewe CONNECT 37 - Manual (Page 40)

- 40
The sound will be reproduced via the TV set's speakers.
Alternatively, connect the digital audio output of the ext.
device to the AUDIO DIGITAL IN socket of the TV set.
Call TV menu.
 Select Connections,
 go to the menu line below.
 Select New devices/modifications.
OK calls the wizard.
OK continue to menu AV equipment selection.

Select device at COMP. IN.
Yellow button: Activate COMP. IN.
For an analogue audio connection the audio is auto-
matically reproduced via the TV set's speakers.
A digital audio signal must be assigned by TV menu
→
Connections → Miscellaneous → Assign digital audio input
to the COMP. IN socket, see page 43.
Playback from the device
Call AV selection.
 Select COMP. IN socket,
OK to switch over.
Adapting the geometry (only possible with certain signals)
This is where the picture can be properly positioned and the position
of the picture (horizontal and vertical) can be moved so that it fills the
entire screen.
Call TV menu.
 Select and adapt the Geometry.
Connecting the audio signal from the PC or from the SetTopBox
Analogue audio signal:
Connect the analogue audio signal from the PC or the
SetTopBox via stereo cable to the AUDIO IN2 jack on the
TV set.
The sound is played via the speakers connected to the TV
set or a speaker system.
Digital audio signal:
ž
the integrated Dolby Digital Decoder or via an exter-
nally connected digital audio amplifier.
Connect the digital audio signal from the PC or the SetTop-
Box via a simple cinch cable to the AUDIO DIGITAL IN
socket on the TV set.
The digital audio input can be assigned to the PC IN socket
via the TV menu
→ Connections → Miscellaneous → Assign
digital audio intput, see page 43.
For an external digital audio amplifier:
ž
nents wizard (see page 42).
Feed the digital audio signal of the AUDIO DIGITAL OUT
socket on the TV set to the external amplifier.
Connecting devices to the Component IN
connection and playback
DVD players/recorders with component video connec-
tions can also be connected to the Cb/Pb Cr/Pr Y sockets
(SD/HD-COMPONENT) of the TV set instead of to the
EURO AV sockets.
The connecting cable with three cinch plugs transmits the picture informa-
tion in better quality than is transmitted by a EURO AV cable. You need
an additional cable for audio transmission.
Connecting the device
Connect the component video outputs of the external
device via a triple cinch cable to the Cb/Pb Cr/Pr Y sockets
on the TV set.
Connect the analogue audio outputs of the external
device to the AUDIO IN1 L/R sockets on the TV set.
Operating additional equipment
OK DVD COMP. IN
AV selection
MI2/DVI VIDEO PC IN VCR AVS HDMI1