Electronic programme guide, Configuring epg – Loewe CONNECT 37 User Manual
Page 31
31 -
You can remove certain stations from the programme
guide. These stations must be deactivated in the Station
selection. First, all stations for which programme infor-
mation can be provided are marked with a
. Stations
without a
are not included in the programme guide.
With the coloured buttons, you can select or deselect
individual stations, select all stations at once or select
only the stations in the favourites list.
Marking the stations according to reception ranges:
analogue stations via antenna/cable for the data
supplied by the current provider.
digital terrestrial stations DVB-T,
digital cable stations DVB-C,
digital satellite stations DVB-S
(1
.
If you want to use EPG for analogue and digital stations,
select on (for DVB + analogue). If you want to use EPG
and only have DVB reception, select on (only for DVB).
If you are not using EPG and therefore do not want to
receive any EPG data, select off.
After making changes in the EPG menu, or each time the
power switch has been switched off, the EPG data must
first be captured. To do this switch on the device and
select (for analogue stations) the station that you have
defined as provider, and let the TV set run for about 1
hour with the selected station. Or switch the TV set to
standby mode. After 2 minutes the display on the TV
lights orange and the EPG data capture begins. When
the data capture process has concluded the display will
return to red. The data capture process is usually per-
formed between 2:00 am and 5:00 am, when the TV
set is in standby mode.
If the TV set is switched on then if there are memorised
programmes the TV set will switch over to these stations.
If the TV set is in standby mode when a memorised pro-
gramme begins, then you can specify here whether the
set should be turned on in this case. If you have set "yes"
in the menu, the TV set will be switched on. If you are
not in at the time, a safety prompt makes sure that the
TV switches off automatically after 5 minutes without
your acknowledgement.
The programmes can be sorted either according to their
start time (sorting according to start time) or according to
stations as in the station list (sorting according to station
/ favourites list).
Calling additional information about the programmes
displayed below the programme list of the broadcasts.
You can call detailed information with the TEXT button if
this function is offered by the TEXT icon in the lower left.
Programming a recording for a recorder
if not, press the blue button.
Mark the desired programme.
Red button: Starts recording wizard.
Change or confirm timer data if necessary (see page 44,
"The direct way to record“).
Then a red dot will be displayed in front of this programme
as identification.
Red button: Deletes the already programmed recording
of the red marked programme from the timer.
If the timer data have been transferred to an external
recorder, then the timer must also be deleted there.
Configuring EPG
Start the EPG menu
if not, press the EPG button.
Call the EPG menu.
Settings in the EPG menu:
Select Provider (only for analogue stations), Station selec-
tion, Data capture, Switch on TV when marked, Sorting.
Explanations of setting possibilities in the EPG menu:
In analogue TV reception there may possibly be different
providers who transmit the EPG data for certain station
packages. To get another range of stations, you can
change the provider with the Provider selection. If the
provider you are looking for is not in the list, then use the
yellow button to perform a Provider search.
The stations offered by the provider will be displayed
in a list.
Station
selection
Data capture
Switch on TV
when marked
Sorting
Electronic Programme Guide
Select provider
END
INFO
OK
rovider
Sortin
Station selection
EPG menu
Data capture
Switch on TV when marked
(1
if upgraded