Loewe CONNECT 37 - Manual (Page 37)

37 -
Yellow button: Place a check mark after the devices to be
connected.
OK Proceed.
The connection plan is displayed again. Connect the
devices to the back of the TV set (in this example the DVD
player (DVD) to AV1, the DVD recorder (DVD•) to AV2).
Select the signal type of your set. Leave the setting on
automatic if you are not sure.
ž
continued on next page
p
Operating additional equipment
Device connection wizard
Connecting additional devices to the TV set
The device connection wizard serves for connecting new devices to the
TV set or changing the wiring.
ž
been logged in in the connection wizard.
Call TV menu.
 Select Connections,
 go to the menu line below.
 Select New devices/modifications.
OK Call wizard.
END: It is possible to run the wizard only partially at any
time.
You have to confirm changes on a page with OK.
Follow the instructions on the TV set.
The following illustrations provide an overview of the
possible options.
The connection diagram shows the devices that are cur-
rently configured. DVD player on AV1 and DVD recorder
on AV2 are factory pre-sets.
OK
END
Connection wizard
Connect the satellite dishes or cable/terrestrial antennas of your AV
equipment (recorder, decoder, ...) to the TV set according to the enclosed
operating manual. The connection wizard assists you when you connect your
equipment to the TV set via the AV sockets AV1, AV2 and AVS or via the
SD/HD-COMPONENT IN or HDMI1/2(DVI)* socket.
Proceed
Connection
diagram
AV equipment
selection
Signal type
Connection
example of a
DVD recorder
to a set with
Digital Recorder
DR+
OK
END
Connection wizard
Specify all new AV devices to be connected and all connection changes to the
existing devices here.
Proceed Connect/disconnect
New devices/modifications
AV equipment selection
DVD player 
DVD recorder 
Video
recorder
Satellite receiver
SetTopBox/dBox
Decoder
Camcorder/camera
Other device(s) to AV1/2/S
Device to COMP.IN
Device to HDMI1/DVI
Device to HDMI2/DVI
DVD
DVD •
VCR
SAT
STB
Decoder
Camera
AV
COMP.IN
HDMI/DVI
HDMI/DVI
OK
END
Connection wizard
Now the TV set assumes that you have connected the following equipment:
Proceed
AVS AV1 AV2 COMP. IN HDMI1 HDMI2
DVD DVD 
OK
END
OK
New devices/modifications
Signal type at socket AV1
Automatic CVBS/YC
CVBS
YC
Proceed
TV
R
TV set
DVD recorder
AV2
ANT2
AUDIO
DIGITAL
IN