Lucent Technologies Cajun M770 - Manual (Page 63)

Cajun M400 Manager User’s Guide 73
System Name Logical name of the system as defined on the SNMP
agent of the device.
Type The agent type.
Upper Backplane
Configuration The configuration of the upper backplane of the
Cajun M770 device, used for ATM switch modules.
Possible values are:
• Not Installed - No upper backplane is installed.
The device can not operate as an ATM switch.
• Single Domain - The upper backplane supports a
configuration of one ATM switch for all 14 slots.
• Dual Domain - The upper backplane supports a
configuration of two separate ATM switches.
One switch includes slots 1 - 7, the other switch
includes slots 8 - 14.
Use Switches (Mode) The state of the usage of hardware switches. The
mode is set to use switches (on) or not to use
switches (off).
VIDP The state of VIDP (VLAN Information Distribution
Protocol). Possible states are “enabled” and
“disabled”.
For more information refer to VIDP on page 13 of
The Reference Guide.
VLAN Bridging VLAN Bridging allows a station on one VLAN to
communicate with a station on a another VLAN
using the bridging capabilities of the M-MLS router.
To enable this feature, the M-MLS router must be
configured to enable bridging between specific
VLANs.
Possible values of the VLAN Bridging field are:
• enabled - If bridging has been configured on
the M-MLS router, the switch allows
communication between the VLANs specified in
the M-MLS router.
• disabled - The switch does not allow inter-
VLAN communication.
Field Name Description