La Crosse Technology WT-5130ER - Manual (Page 14)

14
a. Press and hold
“AL/HOUR”
button for 3 seconds until the
alarm time is flashing.
b. Press and release
“AL/HOUR”
to advance the hour, and
“SET/+/MIN” to advance the minute. The time will
display “PM” if set to PM, and display nothing if set to
AM.
c. The projection alarm clock will revert to normal operation
when no buttons are pressed for 15 seconds. The alarm
is now set and activated.
2. ACTIVATING/DEACTIVATING THE ALARM
a. After entering the alarm setting mode, the alarm is
activated.
b. To toggle between activating and deactivating the alarm,
press the “AL/HOUR” button briefly. “(((●)))”will be
displayed above the time display when the alarm is
activated.
3. TURNING ALARM OFF
(WHILE SOUNDING)
a. While the alarm is sounding, press and release the
“SNOOZE/ADVANCE MODE”
bar to disable the alarm
for 10 minutes.
b. After the
“SNOOZE/ADVANCE MODE”
bar is pressed
the alarm icon will flash.
c. To disable the alarm for 24 hours, press and release any
button other than the “SNOOZE/ADVANCE MODE” bar
or display direction buttons.
NOTE: The alarm will sound for 120 seconds if the “SNOOZE/ADVANCE
MODE”
button is not pressed. The alarm speeds up twice, once
after 20 seconds and again after 50 seconds.