La Crosse Technology WT-5130ER - Manual (Page 6)

6
D
ETAILED SET-UP GUIDE
A. BATTERY INSTALLATION
1. REMOTE TEMPERATURE SENSOR
a. Remove the battery cover.
b. Observing
the correct polarity,
install 2 AA batteries. The
batteries will fit tightly (to avoid
start-up problems make sure that
they do not spring free during installation).
c. Replace the battery cover.
2. PROJECTION ALARM
a. Remove the battery cover.
b. Observe the correct polarity, and install 2 AA batteries.
c. In addition or
instead of
inserting batteries,
the AC adapter
can be used.
Simply plug the
adapter into the
receptacle on the
underneath of the
alarm clock and
then plug in adapter.
d. Replace the battery cover.
e. The projector will activate and remain on if the alarm
clock is plugged in. If only batteries are used, the
projector will only be activated when a button is pressed.
The projection is a red light, not harmful under normal
usage, although care should be taken to not look directly
into the light.
AC adapter
receptacle