La Crosse Technology WT-5130ER - Manual (Page 19)

19
• Do not try to repair the units. Contact La Crosse Technology
for Repairs.
T
ROUBLESHOOTING
Problem The Projection is faint
Solution
1) Use AC adapter
2) Darken surroundings
3) Use fresh batteries (if AC is not used)
Problem The LCD is faint.
Solution Replace the batteries.
Problem “OFL” appears in the indoor temperature LCD.
Solution
1) Move unit to an area with warmer or cooler surrounding
temperature.
2) Current surrounding temperatures are outside measuring
range.
Problem No reception of WWVB signal.
Solution
1) It may help reception to face the front of the projection
alarm in the general direction of Ft. Collins, Colorado.
2) Wait overnight for signal.
3) Be sure the projection alarm is at least 6 feet from any
electrical devices, i.e. TV sets, computers, or other radio
controlled clocks.
4) Remove batteries for five minutes, reinsert and leave the
unit alone overnight without pressing buttons.
5) If problems persist contact La Crosse Technology.
Problem Hour is incorrect (minute is correct).
Solution
Be sure correct time zone and daylight saving time are
selected.
Problem “--.-” appears in outdoor temperature LCD
Solution
1) Check batteries in remote
2) If batteries are replaced in remote, the unit must be re-
started. Remove all batteries, and then follow start up
procedure.
Problem “OFL” appears in the outdoor temperature LCD
Solution
1) Remote temperature is out of range.
2) Check batteries.
3) Interference from an outside source (cordless telephone,
etc.)