Lincoln Electric POWER FEED IM849 - Manual (Page 24)

B-9 OPERATION B-9
PARAMETER
Arc Delay Time
Strike Fault Time
Strike WFS
Strike Volts
Restrike Time
Start WFS/Amps
Start Volts
Start Time
Start Arc Force
Upslope Time
Weld WFS/Amps
Weld Volts
Weld Arc Force
Frequency (AC)
Balance (AC)
Offset (AC)
Arc 2 Phase (if applicable)
Arc 2 Balance (if applicable)
Arc 3 Phase (if applicable)
Arc 3 Balance (if applicable)
Arc 4 Phase (if applicable)
Arc 4 Balance (if applicable)
Downslope Time
Crater WFS/Amps
Crater Volts
Crater Time
Crater Arc Force
Burnback Time
UNITS
seconds
seconds
IPM
volts
seconds
IPM/amperes
volts
seconds
amperes
seconds
IPM/amperes
volts
amperes
hertz
percent
percent
degrees
percent
degrees
percent
degrees
percent
seconds
IPM/amperes
volts
seconds
amperes
seconds
RANGE
0-5.0
0-10.0
from weld table*
from weld table*
0-10.0
from weld table*
from weld table*
0-0.5
from weld table*
0-10.0
from weld table*
from weld table*
from weld table*
10-100
25-75
-50.0 - +50.0
0-359
25-75
0-359
25-75
0-359
25-75
0-10.0
from weld table*
from weld table*
0-10.0
from weld table*
0-2.0
DEFAULT VALUE
OFF
OFF
weld mode dependant
weld mode dependant
OFF
weld mode dependant
weld mode dependant
0.1
weld mode dependant
OFF
weld mode dependant
weld mode dependant
weld mode dependant
weld mode dependant
weld mode dependant
0.0
90
50
180
50
270
50
OFF
weld mode dependant
weld mode dependant
OFF
weld mode dependant
0.2
WHERE IS IT SET?
MSP4 - START OPTIONS
MSP4- SETUP Menu
Left Dual Display
Right Dual Display
MSP4 - SETUP Menu
Left Dual Display
Right Dual Display
MSP4 - START OPTIONS
MSP4 - SETUP Menu
MSP4 - SETUP Menu
Left Dual Display
Right Dual Display
MSP4 - SETUP Menu
AC CONTROL
AC CONTROL
AC CONTROL
AC CONTROL
AC CONTROL
AC CONTROL
AC CONTROL
AC CONTROL
AC CONTROL
MSP4 - SETUP Menu
Left Dual Display
Right Dual Display
END OPTIONS
MSP4 - SETUP Menu
END OPTIONS
POWER FEED™ 10A CONTROLLER
WELD SEQUENCE PARAMETER LIST
* Range depends on the Machine Power Source, Literature and Tables supplied with each unit.