5 completing your installation, Step 1. replace the cabinet cover on your computer, Step 3. wait for your computer to boot up – LSI SYM22801 User Manual
Page 42: Completing your installation, Internal scsi ribbon cable to internal scsi device
2-28
Installing the SYM22801 Host Adapter
2.5 Completing Your Installation
Before replacing the cover on your computer, review this installation
procedure check list. This will save you effort later.
Step 1.
Replace the cabinet cover on your computer.
Step 2.
Plug in all power cords, and switch on power to all devices and
your computer.
Step 3.
Wait for your computer to boot up.
Step 4.
To change the configuration of your host adapter, see
Chapter 3, Configuring the Host Adapter.
Step 5.
Finally, refer to the
PCI SCSI Device Management System
SDMS 4.0 User’s Guide (or the guide for the software you plan
to use) to load the driver software for your particular operating
system.
Verify Installation Procedures
Done
Host adapter connection in PCI bus slot secure
Internal SCSI bus connections secure (pin-1 continuity)
External SCSI bus connections secure
Proper SCSI bus termination established
Unique SCSI IDs set and recorded for each device