LSI SYM22801 - Manual (Page 73)

IX-1
Index
A
active termination
single-ended SCSI 1-3 , A-6
adapter configuration menu
example 3-5
adapter setup menu
CHS mapping 3-9
example 3-7
host SCSI ID 3-8
parity 3-7
removable media support 3-8
SCAM support 3-7
scan order 3-8
spinup delay 3-9
additional adapter
configuring 3-5
alternate CHS mapping 3-9
auto-termination
enabled/disabled 2-19 – 2-22
scheme 2-8
B
BIOS support
for the SYM22801 board 1-1
board characteristics
SYM22801 dimensions A-1
SYM22801 host adapter 1-2
boot order menu
changing an adapter’s boot order 3-5
example 3-4
removing an adapter’s boot order 3-5
setting the boot order 3-4
C
cable detection simulation 2-24
chained connection 2-11 , 2-17
change status on next boot menu
example 3-4
changing the default configuration
SCSI host adapters 3-2
channel switches
incurring improper termination 2-8
settings 2-23
check list
verifying installation procedure 2-28
choosing the mono/color setting 3-5
completing the SYM22801 installation 2-28
configuring the host adapter 3-1 – 3-13
connecting the SCSI peripherals 2-6
connectors
high density 1-3 , A-1 , A-6
LED interface A-9
low density 1-3 , A-1 , A-6
D
description 1-3
detailed installation procedure 2-3 – 2-6
device default settings table 3-2
device selections menu
disconnect 3-12
exiting 3-13
format device 3-12
initial boot 3-12
queue tags 3-12
read write I/O time-out 3-12
restore default setup 3-13
scan for device at boot time 3-12
scan for SCSI logical units 3-12
sync rate 3-11
verify 3-13
width 3-11
device termination
external SCSI device connections 2-20
internal & external SCSI device connections 2-21
internal SCSI device connections 2-19
to both internal connectors 2-22
disconnect option 3-12
display mode
main menu option 3-5
DMA bus master 1-2