Lexmark 5000 Series - Manual (Page 118)

5 Press or repeatedly until Dialing and Sending appears.
6 Press .
7 Press or repeatedly until Auto Fax appears.
8 Press .
9 If an asterisk (*) does not appear next to On, press .
Remote Fax Error
These are possible causes and solutions. Try one or more of the following:
Check phone line
Resend the fax. There may have been a problem with the quality of the telephone line connection.
Lower the transmission speed
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Dialing and Sending appears.
6 Press .
7 Press or repeatedly until Max Send Speed appears.
8 Press .
9 Press or repeatedly until a lower speed appears.
10 Press .
Notes:
• The lower the transmission speed, the longer it will take your fax to send.
• This solution will reduce the speed for future faxes until you reset the transmission speed.
11 Resend the fax.
12 If the problem persists, repeat the previous steps to send the fax at successively lower transmission speeds.
Note: 2400 bps is the lowest transmission speed.
Phone Line Busy
These are possible causes and solutions. Try one or more of the following:
Change redial settings
The printer automatically redials three times at 2-minute intervals. You can change the default settings to redial up
to five times at intervals up to 8 minutes.
118