Lenoxx Electronics HT-395 - Manual (Page 13)

IB-HT395-WM-E-073003
12
1. Connect the 5 satellite speakers and subwoofer as shown on Page 8 (or the QUICK SETUP DIAGRAM packed
with the set).
2. Insert the stereo audio cables (included) into the TV / VCR AUDIO INPUT L (left=white) and R (right=red) j a c k s
on the back of your HOME THEATER SYSTEM, and into the corresponding AUDIO OUT jacks on your TV, this will
allow your TV’s sound to play through your HOME THEATER SYSTEM (If your TV set has AUDIO OUTPUT jacks).
NOTE: Your TV’s sound will come out of the 2 front speakers plus the subwoofer since the default setting for the
sound output is the same as the audio source from the TV (2 channel, STEREO). For “Dolby Pro Logic”
(5.1 channel) sound reproduction, press the SURROUND button. The sound will come out of all 5
speakers plus the subwoofer.
NOTE: On some TVs, you may have to activate the audio out jacks of your TV. See your TV’s booklet.
NOTE: If the signal of your TV is not a true STEREO signal, even though it has stereo output jacks, when you press
the SURROUND button, the sound may not come out from all 5 speakers. This is normal.
NOTE: Some TVs may not allow the Home Theater to play all 5 speakers if the audio output level of the TV is
too low.
3. Insert the AC power cord into an AC outlet.
4. Press the POWER button on the main unit (not the REMOTE) to turn on the main power of the set. Next press the
ON/STANDBY button on the REMOTE to turn the set on (or off).
5. Press the SOURCE button on the main set several times till the TV/VCR indicator lights.
6. Go to Page 20 for detailed instructions.
NOTE: Your cable or antenna connection to your TV are not touched with this connection. Leave your antenna cable
to your TV as you normally would. No changes will be made to your current antenna connections.
TV CONNECTIONS
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8
(OR THE QUICK SETUP DIAGRAM SHEET).
RED & WHITE AUDIO
CABLES (INCLUDED)
Home Theater System + TV
(if your TV has Audio Output jacks)
NOTE: On some TVs, these jacks are in the front,
or your TV may not have these jacks.
(For better sound from TV shows)
NOTE: If your TV does not have audio output
jacks, it can not be used to improve your TV’s
sound.
If you have a cable box or satellite receiver,
you can connect the receiver AUDIO OUTPUT
directly to your TV/VCR AUDIO INPUT on the
back of the HOME THEATER SYSTEM.