Lenoxx Electronics HT-395 - Manual (Page 20)

IB-HT395-WM-E-073003
1. Insert the green 3.5mm audio plug of the AUDIO cable (included) into the PC AUDIO OUT jack of your PC, and
insert the AUX INPUT L (left = white) and R (right = red) plugs into the corresponding AUX INPUT jacks on the
back of your HOME THEATER. This will enable you to hear your computer’s music through your HOME THEATER
SYSTEM.
2. Press the POWER button on the main unit (not the REMOTE) to turn on the main power of this set, next press the
ON/STANDBY button on the REMOTE to turn the set on (or off).
3. Press the SOURCE button several times till the AUX indicator lights.
NOTE: Your computer’s sound will come out of the 2 front speakers plus the subwoofer since the default setting for the
sound output is the same as the audio source from the computer (2 channel, STEREO). For “Dolby Pro Logic”
(5.1 channel) sound reproduction, press the SURROUND button. The sound will come out of all 5 speakers
plus the subwoofer.
NOTE: If the signal of your computer is not a true STEREO signal, even though it has stereo output jack, when you
press the SURROUND button, the sound may not come out from all 5 speakers. This is normal.
NOTE: Some computers may not allow the Home Theater to play all 5 speakers if the audio output level of the
computer is too low.
4. Make sure your computer is on and follow your computer’s instructions.
5. Go to Page 20 for other detailed instructions.
COMPUTER CONNECTIONS
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8
(OR THE QUICK SETUP DIAGRAM SHEET).
19
ONE SET OF AUDIO CABLES WITH 3.5MM
PLUG IS INCLUDED