Lenoxx Electronics HT-395 - Manual (Page 15)

IB-HT395-WM-E-073003
1. Insert the stereo audio cables (included) into the TV/VCR AUDIO INPUT L (left=white) and R (right=red) jacks on
the back of your HOME THEATER SYSTEM, and into the corresponding AUDIO OUT jacks on your VCR, this will
allow your VCR’s sound to play through your HOME THEATER SYSTEM.
NOTE: Your VCR’s sound will come out of the 2 front speakers plus the subwoofer since the default setting for the
sound output is the same as the audio source from the VCR (2 channel, STEREO). For “Dolby Pro Logic”
(5.1 channel) sound reproduction, press the SURROUND button on the REMOTE. The sound will come out
of all 5 speakers plus the subwoofer.
NOTE:Some VCRs may not allow the Home Theater to play all 5 speakers if the audio output level of the VCR is
too low.
2. Connect your VCR to your TV using a coaxial antenna cable (probably already connected), your VCR’s picture
will go to your TV through the antenna connection.
3. Connections of your other antenna cables are not changed when you add your HOME THEATER SYSTEM.
4. Insert the AC power cord into an AC outlet.
5. Press the POWER button on the main unit (not the REMOTE) to turn on the main power of the set. Next press the
ON/STANDBY button on the REMOTE to turn the set on (or off).
6. Press the SOURCE button several times till the TV/VCR indicator lights.
7. Make sure your VCR is on and follow your VCR’s instructions.
8. Go to Page 20 for detailed instructions.
TV + VCR CONNECTIONS
14
Home Theater System + TV + VCR
CONNECT ALL SPEAKERS AS SHOWN ON PAGE 8
(OR THE QUICK SETUP DIAGRAM SHEET).