Lexmark N5 - Manual (Page 23)

18 Setup
Laser 1 (software not previously installed)
Follow the instructions for your operating system.
Windows 98/Me, Windows NT 4.0, Windows 2000, and
Windows XP
You are finished setting up your computer to work with your
network laser printer; however, the printer port must be
defined and the printer software must be installed on each
computer that uses the network printer.
Setting up other computers on your network
Launch the drivers CD that shipped with your printer.
Click Printer Software.
Click the CD icon to install the version of software on
this CD (Quickest Installation Method).
Click Agree on the License Agreement.
Select Local Printer Install, and then click Next.
Select your network printer from the list, and then
select the printer port that consists of the printer
name followed by the last six characters of the printer
adapter MAC address (for example,
Lexmark_E320_0035D0) from the pull-down menu.
Note: If there is not a printer port that
corresponds to the printer adapter MAC
address, see “Manually configure the
network printer” on page 34.
1
2
3
4
5
6
Click Finish.
When installation completes, click OK.
Restart the computer.
Insert the Lexmark Printer Adapter Installation
Software CD.
7
8
9
1