Liebert UPS - Manual (Page 17)

UPS Web management by Liebert IS-WEBRT3 Card
13
Figure 16 UPS On/Off schedule
5.3.3 Network
This page is used to set the Liebert IS-WEBRT3 card Network settings.
IP Address—This section is used to set the Liebert IS-WEBRT3 card IP address.
Subnet Mask—This section is used to set the Liebert IS-WEBRT3 card Subnet Mask.
Gateway—This section is used to set the Liebert IS-WEBRT3 card Gateway.
Obtain an IP address—This section is used to choose to set Liebert IS-WEBRT3 card IP address
manually or via DHCP.
The four sections above can be set in Liebert DeskPro-Net as well. The Liebert IS-WEBRT3 card will
reboot after any of the above are changed.
DNS Server IP
Primary DNS Server IP—This section is used to set the Liebert IS-WEBRT3 card primary DNS
Server IP address.
Secondary DNS Server IP—This section is used to set the Liebert IS-WEBRT3 card secondary
DNS Server IP address. The Liebert IS-WEBRT3 card will use the secondary DNS Server IP address
when the Primary DNS Server IP address is not working.
Ethernet
Connection Type—This section is used to set the communication speed between Liebert IS-
WEBRT3 card and Network. The Liebert IS-WEBRT3 card will reboot after Connection Type is
changed.