Liebert UPS - Manual (Page 9)

Using DeskPro-Net Utility
5
4.3 Advanced Liebert Web Card UPS Setting
DeskPro-Net Utility provides two security functions:
• DeskPro Net Password
• Management Protocol
4.3.1 Enable DeskPro Net Password or Management Protocol
To enable the password function:
1. Start DeskPro-Net Utility by clicking on Start>Programs>DeskPro-Net Utility.
2. Click the Configure function and select the Advanced tab.
3. Enter a password in the first box and enter it a second time as confirmation in the box below.
To enable the Management Protocol function:
1. Start DeskPro-Net Utility by clicking on Start>Programs>DeskPro-Net Utility.
2. Click the Configure function and select the Advanced tab.
3. Check the boxes to enable the HTTP and Telnet function and enter port numbers.
The Liebert IS-WEBRT3 card UPS provides HTTP(WEB) and Telnet to reference any related param-
eter setting for the manager. Concerning security, the manager could use any advanced port setting
with the above two methods. Followings are the descriptions:
1. At advanced setting, two functions were set as activated by using port number 80 and 23.
2. If the boxes are unchecked, the functions will not be available.
3. When set to the other port value, the full IP address must be entered in order to login to the
website or Telnet.
For example,
• If “81” is set as the HTTP port number, then http://192.168.0.177:81 must be typed as the
Web address to connect to Liebert IS-WEBRT3 card UPS’s interface.
• If “24” is set as the Telnet port number, then 192.168.0.177 24 must be typed at Telnet to pro-
ceed to the Telnet screen of Liebert IS-WEBRT3 card.
Figure 6 Advanced setting of Liebert IS-WEBRT3 card UPS
NOTE
After setting a password, write it down and keep it accessible: Without the password, it will not
be possible to give any commands to the Liebert IS-WEBRT3 card using DeskPro-Net Utility
software