Lincoln Electric LN-7 GMA WIRE FEEDERS - Manual (Page 50)

D-3 MAINTENANCE D-3
LN-7 & LN-7 GMA
The following Figures D.1 and D.2 should serve as a
guide to determine if a particular gun or switch can be
connected to the LN-7 GMA and LN-7.
“A” Diameter Hole
to be Concentric to
Wire Size .749/.747 (19.0/18.9)
in. (mm) Diameter Within .008 (.20) F.I.M.
7/64 .152 [#24 Drill]
0.68-5/64 (1.7-2.0) .125 [1/8” (3.2 mm) Drill]
1/16-0.062 (1.6) .078 [5/64” (2.0 mm) Drill]
.045 & .052 (1.1 & 1.3) .062 [1/16” (1.6 mm) Drill]
.023-.035 (0.6-0.9) .055 [(1.4 mm) #54 Drill]
All dimensions in inches and (millimeters).
1/2 Amp AC 24 Volts — Inductive
1/2 Amp DC 24 Volts — Inductive
FIGURE D.1 – LN-7 CONNECTORS
GUN CABLE CONNECTOR REQUIRE-
MENTS TO PERMIT PROPER CONNEC-
TION TO LINCOLN LN-7 GMA AND LN-7
WIRE FEEDER
LN-7 CONNECTOR FOR 1/16-7/64” (1.6-2.0 MM) WIRE)
LN-7 CABLE CONNECTOR FOR .023-.052” (0.6-1.3 mm)
WIRE (FOR ALL OTHER DIMENSIONS, SEE ABOVE).
NOTE: Connector part with .7459/.747 (19.0/18.9)
diameter should be made from brass if it is to be part
of the welding current carrying circuit.
FIGURE D.2 – SWITCH REQUIREMENTS