Lantronix ETS16PR - Manual (Page 29)

Printing on the ETS
ETS Installation Guide 29
Note: Lantronix uses the following convention to identify the TCP ports on
the ETS: 3000 + port number. For example: Port 1 = 3001, Port 2 = 3002,
Port 3 = 3003 etc.
8. If configuring the printer to use a LPR port, select LPR. Identify the appropriate
ETS service to use in the Queue Name field.
To determine the services running on the ETS do the following:
Access the ETS Local> prompt (via telnet or a terminal console).
Type SET PRIV and enter the privileged user password (default password is
SYSTEM ) .
Type SHOW SERVICES LOCAL.
To configure a service, use the following commands from the privileged user
prompt on the ETS:
Local>> DEFINE SERVICE (ETS_HPLaserjet) port
(x) enable
(substitute your own values for the entries in parentheses)
Local>> INITIALIZE DELAY 0
After the reboot use the following command to display the status of the newly defined
service:
Local>> SHOW SERVICE (ETS_HPLaserjet) CHAR
9. Click OK. Click Next.
10. Identify the Manufacturer and Model of the print device used. Provide the
appropriate driver if prompted.