Lantronix ETS16PR - Manual (Page 39)

NetWare Configuration
ETS Installation Guide 39
3. From the main menu, choose Quick Set-Up.
4. When prompted by PCONSOLE, enter the information with which to configure
the print queue.
‹ The print server name (ETS_xxxxxx),
‹ The new printer name (service name, such as ETS_xxxxxx),
‹ The new print queue name, and
‹ The print queue volume (the name of the file server from which the printer
receives print requests).
‹ The remaining fields can be left in their default settings.
5. Press the F10 key to save the print queue information.
6. Reboot the ETS.
NetWare Host Troubleshooting
Table 6-1. NetWare Host Troubleshooting (Bindery Mode)
Area to Check Explanation
The print server
names in
PCONSOLE match
the ETS name and its
service name Use PCONSOLE to check.
The ETS NetWare
access table Use the Show Protocols NetWare Access
command. Scanning too many file servers can
cause a delay between jobs. Configure the
access list to only scan for jobs on the file servers
of interest.
Table 6-2. NetWare Host Troubleshooting (NDS)
Area to Check Explanation
The ETS NetWare
access table Use the Show Protocols NetWare Access
command. By default, only local file servers are
scanned for queues.
The ETS login
password and the
queue password on
the file server The passwords must match or the ETS will not
be able to log into the file servers to scan for
jobs.
The ETS has
successfully attached
to the queue Type NETSTAT at the Local> prompt. This will
display information about fileservers, printers,
and queues that the ETS has found. If a queue is
in JobPoll, the ETS has successfully attached to
the queue.