Frequently-used commands, Conventions, Server commands – Lantronix ETS16PR User Manual
Page 61: F: frequently-used commands
ETS Installation Guide
61
F
F
:
:
F
F
r
r
e
e
q
q
u
u
e
e
n
n
t
t
l
l
y
y
-
-
U
U
s
s
e
e
d
d
C
C
o
o
m
m
m
m
a
a
n
n
d
d
s
s
This appendix lists some of the most frequently-used commands of the Multiport
Device Server command set. More information about the command set, including
additional options, can be found in the Device Server Reference Manual located on
the CD-ROM and available for download from
Conventions
Please note the following before continuing:
Commands are divided into Server (general), Port, and Protocol sections.
Within each section, commands are listed alphabetically.
Commands may require privileged user status. Enter Set Privileged, then
enter the privileged password when prompted.
When you enter a Define (or Purge) command, you must reboot the ETS for
the command to take effect. Alternately, you can issue several Set
commands and then a Save command to make the Set commands take
effect without rebooting.
When the abbreviated syntax “{EN/DIS}” is shown, you must choose either
Enabled or Disabled to complete the command.
When 2 is shown as the port number, enter a single port number, a list of
port numbers separated by commas, a range of port numbers separated by
dashes, or the word all.
Server Commands
Table F-1. Frequently-used Server Commands
Command
Option(s)
Description
servicename
Makes a connection to a LAT service.
LOCAL num
Makes a connection to the specified local port.
RLOGIN host
Makes an Rlogin connection to the specified
host (text name or numeric IP address).
TCP host
Makes a raw TCP connection to the specified
host (text name or numeric IP address).
CONNECT option
TELNET host
Makes a Telnet connection to the specified host
(text name or numeric IP address).
DEFINE SERVER BOOTP {EN/DIS}
Enables or disables querying for a BOOTP host
at system boot time.
DEFINE SERVER DHCP {EN/DIS}
Enables or disables querying for a DHCP host
at system boot time.