LevelOne WBR-6005 - Manual (Page 58)

◆ MAC Address — The shared physical layer address for the Wireless
Router‘s LAN ports.
◆ DHCP Server — Enable this feature to assign IP settings to wired and
wireless clients connected to the Wireless Router. The IP address,
subnet mask, default gateway, and Domain Name Server (DNS)
address are dynamically assigned to clients. (Options: Enable, Disable;
Default: Enable)
◆ Start/End IP Address — Specify the start and end IP addresses of a
range that the DHCP server can allocate to DHCP clients. Note that the
address pool range is always in the same subnet as the unit‘s IP
setting. The maximum clients that the unit can support is 253.
◆ Primary DNS Server — The IP address of Domain Name Servers on
the network. A DNS maps numerical IP addresses to domain names
and can be used to identify network hosts by familiar names instead of
the IP addresses.
◆ Secondary DNS Server — The IP address of the Secondary Domain
Name Server on the network.
◆ Default Gateway — The default gateway is the IP address of the
router for the Wireless Router, which is used if the requested
destination address is not on the local subnet.
◆ Lease Time — Select a time limit for the use of an IP address from the
IP pool. When the time limit expires, the client has to request a new IP
address. The lease time is expressed in seconds. (Options: Forever, Two
weeks, One week, Two days, One day, Half day, Two hours, One hour,
Half hour; Default: One week)
◆ Statically Assigned — Up to three devices with specific MAC
addresses can be assigned static IP addresses. That is, the DHCP server
always assigns these devices the same IP addresses.
◆ LLTD — Link Layer Topology Discovery (LLTD) is a Microsoft proprietary
discovery protocol which can be used for both wired and wireless
networks. (Options: Disable/Enable, Default: Enable)
◆ IGMP Proxy — Enables IGMP proxy on the Wireless Router. (Options:
Disable/Enable, Default: Disable)
◆ UPNP — Allows the device to advertise its UPnP capabilities. (Default:
Enable)
◆ Router Advertisement — Enables the sending and receiving of
routing advertisements to discover the existence of neighboring
routers. (Options: Disable/Enable, Default: Disable)
◆ PPPoE Relay — When enabled, the Wireless Router will forward PPPoE
messages to clients. Clients are then able to connect to the PPPoE
service through the WAN port. (Options: Disable/Enable, Default:
Disable)
– 58 –
C HAPTER 6 | Internet Settings
LAN Setting