Lexmark 4097-00X - Manual (Page 28)

Repair Information 4-3
4097-00X
Access Cover Removal
1. Open the access cover.
2. Push the mounting tabs toward the center of the machine.
3. Remove the access cover.
Buttons / Lenses Removal
1. Remove the front cover.
2. Depress the button clips and remove the buttons.
3. Lift and remove the lenses.
Carrier Belt / Idler Pulley Removal
1. Remove the front cover.
2. Remove the printhead carrier without disconnecting the system
board cables.
3. Remove the carrier belt.
4. Depress the latch on the idler pulley, slide it to the left and
remove.
Carrier Frame Assembly / Base Removal
1. Remove the front cover.
2. Remove the six screws that secure the carrier frame to the base
assembly.
3. Remove the paper guide.
4. Tilt the lower part of the carrier frame up and remove the carrier
frame.
Note: Be sure the parallel cable clips are not trapped inside the
cover.