Lexmark 4097-00X - Manual (Page 33)

4-8 Service Manual
4097-00X
Rear Cover Removal
1. Open the rear cover.
2. Push the mounting tabs toward the center of the machine and
remove the rear cover.
Sheet Feeder Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Remove the two screws that hold the sheet feeder to the carrier
frame.
4. Remove the screw from the gear plate.
5. Depress the sheet feeder latch from the carrier frame and
remove the sheet feeder.
Small Feed Rollers / EOF Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Remove the sheet feeder
4. Facing the rear of the machine, remove the small feed rollers.
5. Unhook the four small feed roller springs from the carrier frame
and remove the small feed roller assemblies.
6. Slide the EOF flag to the right and remove. Note the positioning
of the tension spring.
System Board Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Disconnect all connectors from the system board.
4. Remove the four system board screws from the system board.
Note when removing the system board, be careful not to
damage the end of form EOF flag.
5. Remove the system board.