Lexmark 4097-00X - Manual (Page 30)

Repair Information 4-5
4097-00X
Gutter Pad / Maintenance Station Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Remove the two screws from the rear of the maintenance
station.
4. Depress the two clips on the rear of the carrier frame and
remove the maintenance station.
5. Remove the spring and actuator lever from the front of the
maintenance station.
6. Lift and remove the wiper assembly.
7. Remove the cap assembly.
8. Remove the felt gutter pad.
Note: If any glue is present on the maintenance station during
removal, replace the entire maintenance station.
Large Feed Roller Removal
1. Remove the front cover.
2. Remove the carrier frame.
3. Remove the exit roller.
4. Remove the small feed roller assemblies.
5. Remove the EOF flag.
6. Remove the mid frame.
7. Remove the bushings at the ends of the large feed roller and
remove the roller.
Maintenance Wiper and Cap Removal
1. Remove the front cover.
2. Push the carrier to the left away from the maintenance station.
3. Gently pull the cap and wiper off their mountings.
Repair.fm Page 5 Wednesday, December 2, 1998 1:40 PM