LSI 40909G-S - Manual (Page 22)

3-4 Software Installation
3.1.4 Identifying the FC Disks
The probe-scsi-all command is used to identify the FC disk devices
on your LSI Logic/IntraServer adapter, as shown in Figure 3.2 .
Figure 3.2 FC Disk Devices Listing
ok probe-scsi-all
/pci@1f,0/pci@1/IntraServer,Ultra2-scsi@1
Target 0
Unit 0 Disk IBM DNES-309170W SA30
/pci@1f,0/pci@1/pci@2/IntraServer,fc@7
MPT Firmware Version 1.00
Target 0
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 220000203710d063 ID 111d2
Target 1
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 220000203710c09b ID 111d6
Target 2
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 220000203710b066 ID 111d5
Target 3
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 220000203710b063 ID 111d3
Target 4
Unit 0 Disk SEAGATE ST39173FC 6258
WWN 220000203710b04f ID 111d4
Target 5
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 2200002037104f73 ID 111d9
Target 6
Unit 0 Disk SEAGATE ST39173FC 6615
WWN 2200002037102d0f ID 111d1