LSI 40909G-S - Manual (Page 34)

3-16 Software Installation
itmpt<n>: Could not allocate
memory to read configuration data. The driver was unable to allocate memory required to process
the configuration data. This means that the configuration was
not properly determined. To fix this you may need to manually
configure the driver using the itmpt.conf file.
itmpt<n>: Unable to make reset
notification callbacks. The itmpt was unable to notify the target device driver of a bus
reset. The target driver may start to malfunction.
itmpt<n>: ddi_dma_unbind_handle:
failed The operating system failed to respond to the named routine in
a known manner. This is a fatal error that is not recoverable.
Please report this error to technical support.
itmpt<n>: ddi_dma_numwin() failed. –
itmpt<n>: ddi_dma_getwin() failed. –
itmpt<n>: ddi_dma_alloc_handle:
xxh unknown/impossible. –
itmpt<n>:
ddi_dma_buf_bind_handle:
DDI_DMA_INUSE impossible. –
itmpt<n>:
ddi_dma_buf_bind_handle: xxh
unknown/impossible. –
itmpt<n>: No KeyROM found.
Hardware contains no valid license. The adapter is not a valid LSI Logic/IntraServer adapter
licensed for use with Solaris.
itmpt<n>: Hi-level interrupts not
supported. The adapter is in a slot that cannot be used with this driver.
Please try moving the adapter to a different PCI slot.
itmpt<n>: Device in a slave-only slot
and is unusable. –
itmpt<n>: Failed to attach. This
adapter will not be installed. Because of one of the previous two errors, this adapter could
not be "attached" to the I/O subsystem and will not be
accessible. See the previous error message and solve that
problem.
itmpt<n>: Unable to obtain soft
state structure. The driver was unable to initialize a required data structure and
therefore did not load. Please call technical support.
itmpt<n>: Failed to attach interrupt
handler. The driver was unable to initialize the interrupt handler as
required. Please call technical support.
Table 3.2 Error Messages (Cont.)
Error Messages Explanation