Warning, Diagrams, Connection diagram – Lincoln Electric COMMANDER IM544-B User Manual

Page 35: Commander 400

Advertising
background image

F-3

DIAGRAMS

F-3

COMMANDER 400

CONNECTION DIAGRAM:

CONTROL MODULE. INCORRECT SWITCH POSITION COULD RESULT IN DAMAGE TO THE CONTROL MODULE AND/OR POWER SOURCE.

K487-25

SPOOL GUN

BE SURE THAT CONTROL MODULE MODE SLIDE SWITCH IS IN THE "LINCOLN" (CONTACT CLOSURE) POSITION BEFORE ATTEMPTING TO OPERATE

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO "WIRE WELDING CV".

K691-10

INPUT CABLE

K488 SG

DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

Keep guards in place.

or service this equipment.

TO WORK

RECEPTACLE

CAUTION :

AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE

CONTROL MODULE

Keep away from moving parts.

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE

Only qualified personnel should install,use

Do not touch electrically live parts.

before servicing.

Disconnect NEGATIVE (-) BATTERY LEAD

Do not operate with panels open.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE

APPLICATIONS. SEE OPERATING MANUAL.

ELECTRODE CABLE

TO CONTROL MODULE

COMMANDER 400 STICK & WIRE / K691-10 / K488 / K487 SPOOL GUN CONNECTION DIAGRAM

M18284

WARNING

RECEPTACLE

TO WORK

14 PIN WIRE FEEDER

115V RECEPTACLE

ELECTRODE

6 PIN REMOTE

N.D. PLACE IDLE SWITCH IN "HIGH" IDLE POSITION.

"REMOTE" POSITION.

PLACE WELDING TERMINALS SWITCH TO "REMOTELY CONTROLLED" POSITION.

N.C. IF OPTIONAL K857 REMOTE OUTPUT CONTROL IS CONNECTED TO 6 PIN RECEPTACLE,PLACE LOCAL REMOTE SWITCH IN

THE ENGINE WELDER OPERATING MANUAL.

12-13-96

Advertising