Lincoln Electric COMMANDER IM544-B - Manual (Page 38)

F-6 DIAGRAMS F-6
COMMANDER 400
CONNECTION DIAGRAM:
CAUTION :
ELECTRODE
14 PIN AMPHENOL TO WORK
TO WORK
WIRE
COMMANDER 400 STICK & WIRE / K867 / LN-8 CONNECTION DIAGRAM
FEEDER
K196
K867 UNIVERSAL ADAPTER PLUG
INPUT CABLE
ELECTRODE CABLE TO WIRE FEED UNIT
12-13-96
2 4
76 77
ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN
SPARE
82
Only qualified personnel should install,use
81
before servicing.
or service this equipment. Keep away from moving parts.
N.C.
Keep guards in place.
Disconnect NEGATIVE (-) BATTERY LEAD Do not touch electrically live parts.
21
Do not operate with panels open.
GND
N.D.
32
2
WARNING
LN-8
N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE APPICATIONS. SEE OPERATING MANUAL.
75 32 31 41 42
N.C. INSULATE EACH UNUSED LEAD INDIVIDUALLY. N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE RANGE SWITCH TO "WIRE WELDING CV". N.D. SPLICE LEADS AND INSULATE.
THE ENGINE WELDER OPERATING MANUAL.
PLACE LOCAL / REMOTE SWITCH IN "REMOTE" POSITION.
GND
31 4 21 B
C A
S22913