Lenovo 9354 User Manual

Page 58

Advertising
background image

Diagnostic Error Code

FRU/Action

015-196-XXX USB port test halt, error threshold exceeded

1. Press F3 to review the log file

2. Re-start the test to reset the log file

015-197-XXX USB port test warning

1. Make sure the component that is called out is

connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39

2. Re-run test

3. Replace the component that is called out in warning

statement

4. Replace the component under test

015-198-XXX USB port test aborted

1. If a component is called out, make sure it is

connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39

2. Flash the system and re-test. See "Flash update

procedures" on page 467

3. Go to "Undetermined problems" on page 65

015-199-XXX USB port test failed, cause unknown

1. Go to "Undetermined problems" on page 65

2. Flash the system and re-test. See "Flash update

procedures" on page 467

3. Replace component under function test

018-000-XXX PCI Card Test Passed

No action

018-0XX-XXX PCI Card Failure

1. Riser card, if installed

2. System board

018-195-XXX PCI Card Test aborted by user

1. PCI card

2. Information only Re-start the test, if necessary

018-196-XXX PCI Card test halt, error threshold exceeded

1. Press F3 to review the log file

2. Re-start the test to reset the log file

018-197-XXX PCI Card test warning

1. Make sure the component that is called out is

connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39

2. Re-run test

3. Replace the component that is called out in warning

statement

4. Replace the component under test

018-198-XXX PCI Card test aborted

1. If a component is called out, make sure it is

connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 39

2. Flash the system and re-test. See "Flash update

procedures" on page 467

3. Go to "Undetermined problems" on page 65

018-199-XXX PCI Card test failed, cause unknown

1. Go to "Undetermined problems" on page 65

2. Flash the system and re-test. See "Flash update

procedures" on page 467

3. Replace component under function test

52

ThinkCentre Hardware Maintenance Manual

Advertising
This manual is related to the following products: