Lenovo 9354 - Manual (Page 110)

Replacing the microprocessor
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait
three to five minutes to let the computer cool before opening the computer cover.
Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:http://www.lenovo.com/support
This section provides information on how to remove and replace the microprocessor.
To remove or replace the microprocessor, do the following:
1. Remove the cover. See "Removing the cover" on page 94.
2. Lift the fan duct off the heat sink fan.
3. Disconnect the heat sink and fan assembly cable from the system board. See "Locating parts on the
system board" on page 95.
4. Rotate handle 1 to release the heat sink clamp and then disengage the clamp from the plastic retention
bracket.
5. Lift the heat sink and fan assembly off the system board. Place the heat sink on its side so that the
thermal grease does not come in contact with anything.
Note: You might have to gently twist the heat sink to free it from the microprocessor.
6. To release the microprocessor 2 from the system board socket, lift the small handle 1 .
104 ThinkCentre Hardware Maintenance Manual