LSI 320 - Manual (Page 20)

2-4 Detailed Host Adapter Installation
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Step 4. Be sure to tighten the bracket screw into the bracket securely
before you connect the internal and external SCSI devices.
2.2 SCSI Device Cables
For reliable Ultra320 operation, be sure to use an Ultra320 rated SCSI
cable. The Ultra320 SCSI cable also has built-in low voltage differential
and single-ended termination. This built-in feature is included because
most Ultra320 SCSI hard disk drives are not made with on-board low
voltage differential termination.
2.2.1 Internal SCSI Cables
You can connect all internal SCSI devices to the host adapter with an
unshielded, twisted pair, 68-pin ribbon cable. Some 68-pin internal cables
come with a low voltage differential and single-ended terminator on one
end, which must be furthest from the host adapter.
Figure 2.3 and
Figure 2.4 show internal cables with and without a terminator.
Figure 2.3 SCSI Cable - 68-pin High Density with Terminator
n
Figure 2.4 SCSI Cable - 68-pin High Density without Terminator
Terminator