Linksys 2.4 GHz 802.11g Wireless-G ADSL Gateway with 2 Ports WAG54GP2 User Manual
Page 36
27
Chapter 4: Configuring the Gateway
The Setup Tab
Wireless-G ADSL Gateway with 2 Phone Ports
•
Hop Count. Hop Count is the number of hops to each node until the destination is reached (16 hops
maximum). Enter the Hop Count in the field.
•
Show Routing Table. Click the Show Routing Table button to open a screen displaying how data is routed
through your network. For each route, the Destination IP address, Subnet Mask, Gateway, and Interface
are displayed. Click the Refresh button to update the information. Click the Close button to return to the
previous screen.
PVC Routing Policy. PVC stands for "Permanent Virtual Circuit". It is a virtual circuit link between two nodes for
ATM (Asynchronous Transfer Mode) network. Each PVC functions as a separate Internet connection. PVC settings
are for ADVANCED USERS ONLY. The PVC routing table allows you to select which traffic type to be forwarded to
which PVC. Click the PVC Routing Setting button to open the PVC Routing table.
•
Please select active connection. Select your active Internet connection from this pull-down menu.
•
Destination. Enter the destination Internet IP Address and Network Mask where this PVC will send data.
•
Source. Enter the source IP Address and Network Mask where this PVC will originate.
•
Source Mac. Enter the source MAC Address of the network PC where the data originates.
•
Protocol. Enter the data’s protocol, either TCP,UDP or ALL.
•
Dst Port. Enter the destination port number where this PVC will send data.
•
Src Port. Enter the source port number where this PVC will originate.
•
802.1D User Priority. This uses the 802.1D header requirement to set prioritization. The number range is
0~7 depending on the type of services, with 7 having the highest priority.
•
802.3 Type/Length. Enter the Ethernet type for a specific protocol.
•
802.1Q Vlan ID. This is the ID for VLANs, from 0 ~ 4095
•
PacketLength. This is the total packet length of an IP packet, from 20byte~65535bytes.
•
DSCP. Enter the TOS (Type of Service) in the IP header here. Possible values are 0x00 to 0x3f, the last two
Hex values are the variables.
•
Apply. Check this and click the Save button to apply your changes
When finished making your changes on this tab, click the Save Settings button to save these changes, or click
the Cancel Changes button to undo your changes.
Figure 4-14: Routing Table
Figure 4-15: PVC Selection Table