Linksys 2.4 GHz 802.11g Wireless-G ADSL Gateway with 2 Ports WAG54GP2 - Manual (Page 58)

49 Chapter 4: Configuring the Gateway
The Administration Tab
Wireless-G ADSL Gateway with 2 Phone Ports
Diagnostics
Ping Test
Ping Test Parameters
Ping Target IP. Enter the IP Address that you want to ping in the field. This can be either a local IP or an Internet
IP address.
Ping Size. Enter the size of the ping packets.
Number of Pings. Enter the number of times that you want to ping.
Ping Interval. Enter the ping interval in milliseconds.
Ping Timeout. Enter the time in milliseconds.
Ping Result. The results of the ping test will be shown here.
Click the Start Test button to start the Ping Test.
Backup&Restore
The Backup&Restore tab allows you to back up and restore the Gateway’s configuration file.
To back up the Gateway’s configuration file, click the Backup button. Then follow the on-screen instructions.
To restore the Gateway’s configuration file, click the Browse button to locate the file, and follow the on-screen
instructions. After you have selected the file, click the Restore button.
Factory Defaults
Restore Factory Defaults. If you wish to restore the Gateway to its factory default settings and lose all your
settings, click Yes.
To begin the restore process, click the Save Settings button to save these changes, or click the Cancel Changes
button to undo your changes.
Figure 4-43: Administration Tab - Diagnostics
Figure 4-44: Administration Tab - Backup&Restore
Figure 4-45: Administration Tab - Factory Defaults