Linksys 2.4 GHz 802.11g Wireless-G ADSL Gateway with 2 Ports WAG54GP2 - Manual (Page 55)

46 Chapter 4: Configuring the Gateway
The Administration Tab
Wireless-G ADSL Gateway with 2 Phone Ports
SNMP
SNMP is a popular network monitoring and management protocol. To enable SNMP, click Enabled. To disable
SNMP, click Disabled.
If enabled, then specify the IP address(es) allowed to have SNMP access. Select All to allow all IP addresses with
no restrictions, IP address to specify a single IP address, or IP range to specify a range of IP addresses.
Device Name. Enter the name of the Gateway.
Get Community. Enter the password that allows read-only access to the Gateway’s SNMP information.
Set Community. Enter the password that allows read/write access to the Gateway’s SNMP information.
SNMP v3: Rw User. Enter the user name of the user with read/write access.
Authentication Protocol. Select the method used to authenticate the read/write user.
Authentication Password. Enter the actual password that will authenticate the read/write user.
Privacy Password. Enter a second password for added security. This will be associated with the DES privacy
protocol.
Trap Management: Trap to. Enter the IP address of the remote host computer that will receive the trap
messages.
UPnP
UPnP allows Windows XP to automatically configure the Gateway for various Internet applications, such as
gaming and videoconferencing.
UPnp. To enable UPnP, click Enable.
Please select a PVC connection to bind. The Gateway uses one Permanent Virtual Circuit (PVC) connection, so
select the number 1 from the drop-down menu.