Lexmark 5600 Series - Manual (Page 148)

4 Press the arrow buttons until Dialing and Sending appears, and then press .
5 Press the arrow buttons until Dial Method appears, and then press .
6 Press the arrow buttons until Behind PBX appears, and then press to save the setting.
Printer receives a blank fax
These are possible causes and solutions. Try one or more of the following:
C
HECK ORIGINAL DOCUMENT
Ask the sender to verify the original document was loaded correctly.
C
HECK INK
Check the ink levels, and install a new print cartridge if necessary.
C
HECK CARTRIDGES
1 Remove the print cartridges.
2 Make sure the sticker and tape have been removed.
1 2
3 Reinsert the print cartridges.
Received fax has poor print quality
These are possible solutions. Try one or more of the following:
R
EVIEW CHECKLIST FOR SENDER
• Check that the quality of the original document is satisfactory.
• Resend the fax. There may have been a problem with the quality of the telephone line connection.
• Increase the fax scan resolution.
C
HECK INK
Check the ink levels, and install a new print cartridge if necessary.
D
ECREASE THE TRANSMISSION SPEED
1 From the printer control panel, press .
2 Press the arrow buttons until Fax Setup appears, and then press .
3 Press the arrow buttons until Dialing and Sending appears, and then press .
Troubleshooting
148