Lexmark IBM 9077 - Manual (Page 127)

Configuration of IP-Forwarding Media Cards 109
if-config:
Ethernet interface configuration.
Enumerated field, values:
autonegotiate: autonegotiate
10-half: 10 BaseT Half Duplex
10-full: 10 BaseT Full Duplex
100-half: 100 BaseT Half Duplex
100-full: 100 BaseT Full Duplex
super> set if-config = 100-full
super> write
CARD2/ written
super> quit
#
The configuration of the Ethernet card is now completed. Issue grwrite -v
and grreset <slot_number> . Communication between the GRF’s Ethernet card
and attached devices should work now. To monitor the card, use the maint
commands we found to be useful in the following section.
4.1.6 Some maint Commands for the Ethernet Media Cards
The maint commands operate on the SP Switch control board and require the
card’s slot number, which you may find with the grcard command.
Prepare to use maint with the following steps:
• First, switch to maint ’s GR 66> prompt with the grrmb command.
• At the GR66> prompt, change to the prompt for the specific card you are
interested in. For a card in slot 7, this would be the command port 7 .
• As a result, the following message along with the changed prompt is
returned:
Current port card is 7
GR 7>
• At this prompt maint commands can be issued.
• To leave the GR 7> prompt, enter quit .
The following maint commands were most useful for us:
maint 1 -to view the list of receive side (RX) maint commands.
maint 101 -to view the list of transmit side (TX) maint commands.
maint 3 -to display configuration and status of all ports.
maint 4 -to display media statistics for both the input side and the output side
for one or all eight interfaces. If you do not specify one interface,