Lexmark IBM 9077 - Manual (Page 64)

46 IBM 9077 SP Switch Router: Get Connected to the SP Switch
2.4.2.2 The enrmnode Command
The
enrmnode command is used to remove an extension node from the SDR
DependentNode class and can also be executed using smit. The fast path for
smit is
delete_extnode . Its options are shown in Table 8.
Table 8. enrmnode Command Options
Flags SMIT Option Description
-r Reset the
extension node Specifies whether the enadmin command is to be
activated after the enrmnode command
completes. With this option the user does not
have to explicitly issue the
enadmin command. If
the specification is yes , the -r option is part of the
command. If the specification is no , the -r option
is not part of the command.
Node number This is the node number the extension node
logically occupies in the RS/6000 SP.
Note that this command only affects the SDR, unless the -r option is used.
The -r option should be issued only if endefadapter has been executed for
the extension node.
When the GRF is properly configured and powered on, with the SP Switch
Router Adapter inside, it periodically polls the Control Workstation for
configuration data. The
-r option or enadmin command is not required to
activate the polling here.
Attention
Note that this command only affects the SDR, unless the -r option is used.
This command should be issued with a -r flag, because the enadmin
command is not available for the extension node after enrmnode is executed,
since the extension node has been removed from the SDR.
Attention