Perle Systems 833IS - Manual (Page 6)

FEDERAL COMMUNICATIONS COMMISSION (FCC) REQUIREMENTS.
This product complies with Part 68 of the FCC rules. If requested, you must provide the
telephone company with the FCC registration number, make and the model number of this
device. This information can be found on the product label affixed to the back of the unit.
This equipment is designed to be connected to the telephone network or premises wiring using
a compatible modular jack which is part 68 compliant.
This equipment is not intended to be used on public coin phone service or be connected to
party line service.
If this equipment malfunctions, it may cause harm to the telephone network. In such an event,
the telephone company may request that you disconnect the equipment from the network until
the problem is corrected. The may also notify you in advance that temporary discontinuance
of service may be required. If advance notice isn't practical, the telephone company will notify
the customer as soon as possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or
procedures that could affect the operation of the equipment. If this happens, the telephone
company will provide advance notice in order for you to make the necessary modification to
maintain uninterrupted service.
If you experienced trouble with this equipment, please contact the Perle Technical Assistance
Center at the following address for information about obtaining service;
Perle Systems Limited
60 Renfrew Drive
Markham, Ontario
L3R 0E1
1-800-33 PERLE
All repairs should only be performed by Perle Systems Limited or an authorized agent of
Perle .
When ordering service from the telephone company, you may need to provide the following
information;
Facility Interface Codes (FIC): 02IS5
Service Order Code (SOC): 6.0Y
USOC Jack: RJ49C
REN: Not applicable