Panasonic KX-FC241AL - Manual (Page 68)

9. Programmable Features
66
9.2 Basic features
Code #01: Setting the date and time
SET DATE & TIME
PRESS SET
See page 27 for details.
Code #02: Setting your logo
YOUR LOGO
PRESS SET
See page 28 for details.
Code #03: Setting your fax number
YOUR FAX NO.
PRESS SET
See page 29 for details.
Code #04: Printing a sending report
SENDING REPORT
=ERROR [ ±]
To print a sending report for fax transmission
results (page 44).
“
ERROR” (default): A sending report will be
printed only when fax transmission fails.
“
ON”: A sending report will be printed after every
transmission.
“
OFF”: Sending reports will not be printed.
Code #06: Changing the ring setting in FAX
ONLY mode
FAX RING COUNT
RINGS=2 [ ±]
To change the number of rings before the unit
answers a call in FAX ONLY mode.
You can select “
2” (default), “3”, “4”, “5”, “6”,
“ 7”, “8” or “9”.
Note:
L Set feature #77 to “ FAX ONLY” (page 70)
beforehand.
Code #06: Changing the ring setting in
TAM/FAX mode
TAM RING COUNT
RINGS=2 [ ±]
To change the number of rings before the unit
answers a call in TAM/FAX mode. You can select
“
2” (default), “3”, “4”, “5”, “6”, “7” or “AUTO”.
See page 51 for details.
Note:
L Set feature #77 to “ TAM/FAX” (page 70)
beforehand.
L You can also program this feature with the
cordless handset (page 61).
Code #10: Changing the maximum recording
time for incoming messages
RECORDING TIME
=NO LIMIT [ ±]
“ 1 MINUTE”: Up to 1 minute.
“ NO LIMIT” (default): Unlimited within the voice
memory capacity (page 107).
“
GREETING ONLY”: The unit plays the greeting
message but does not record caller messages.
Note:
L You can also program this feature with the
cordless handset (page 61).
Code #11: Setting the remote operation ID
REMOTE TAM ID
ID=
A 3-digit remote operation ID must be entered
when operating the answering system remotely.
This ID prevents unauthorised parties from
listening to your messages remotely. After you
store your remote operation ID, remote operation
is possible.
1. Press {MENU}.
2. Press {#}, then {1}{1}.
3. To activate the remote operation feature,
enter a 3-digit remote operation ID.
L To deactivate the remote operation
feature, press {*}.
4. Press {SET}.
5. Press {MENU}.
Note:
L You can also program this feature with the
cordless handset (page 61).
Code #13: Setting the dialling mode
(For Australian users only)
DIALLING MODE
=TONE [ ±]
If you cannot dial, change this setting depending
on your telephone line service.
“
TONE” (default): For tone dial service.
“ PULSE”: For rotary pulse dial service.
Note:
L You can also program this feature with the
cordless handset (page 79).
FC243AL-PFQX2096ZA-en.book Page 66 Thursday, September 30, 2004 3:37 PM